Cooling Tower Motor

TRIPLE-D Cooling Tower Motor special design for Cooling Tower Fan. Cooling tower motor specially designs for work in humidity area at continually.
Mounting Type:
Flange (B5)
Frame:
All Cooling Tower Motor is supplied in a robust, rugged cast iron frame.
Ratings:
All Cooling Tower Motors are continuous (S1) rated to comply with performance standards.
Voltage and Frequency:
Cooling Tower Motor Supply volts 415 ± 5% 3 phase 50 Hz. ± 3% We are also capable of Manufacturing three-phase motor in different volts and frequency Like 220, 380, 460, 525.
Protection:
We are Providing Cooling Tower Motor with IP55. Motor relative humidity up to 90%.
Shaft:
Cooling Tower Motor Shaft is Mead by stainless steel material AISI-410. Nut and washer are made for stainless steel AISI-202. It can make protection against corrosion. Motor shaft extended so cooling fan fitted properly.
Duty & Insulation:
Insulation class “F” with constant duty (s1) Cooling tower motor design for Working S1 Duty. For continues working.
Bearing and Oil Seal:
Oil Seal fitted with Flange & Shaft so that out of reach water partial or moisture inside a motor. Bearings are double shielded (ZZ or 2RS) and pre-lubricated with high temp grease for good life of bearings.
Enclosure:
All Cooling Tower motor Supply with Enclosure T.E.S.C. (Totally Enclosed surface Cooled)